VSP systems are created to meet the widest variety of pumping applications using solar energy.
The combination of VASCO Solar – VAriable Speed COntroller inverters with the complete range of stainless steel submersible pumps ranging from 4” to 10” offers a solution of superior quality, unique in its reliability, variety and performance.
Whatever the demand for water, there is always a VSP system that can satisfy it.
VASCO Solar - VAriable Speed COntroller
It is able to convert DC voltage coming from solar panels into AC voltage for powering any pump driven by a three-phase motor.
Pump speed is constantly adapted to available solar irradiation thus maximising the amount of pumped water and making possible operation even in conditions of low sunlight.
It also offers complete pump protection against surges, overloads and dry running.
MPPT: always the maximum
power available
Based on the varying conditions of solar irradiation and temperature, MPPT (Maximum Power Point Tracking) maximises the electrical power drawn from the panels and therefore the amount of water pumped.
The greater the solar irradiation the faster the pump’s rotation speed, and consequently water flow increases.
When solar irradiation decreases (due to clouds or the different times of day), the pump reduces frequency and therefore the flow, but it continues to provide water until the irradation falls below a minimum level necessary to ensure operation.
Advanced connectivity
The device can be connected to:
-
An alarm
-
A motor run/stop signal
-
A pressure sensor or a flow sensor for monitoring
-
Up to 4 digital inputs for pump start and stop (float switch, level sensors, etc.)
-
Modbus RTU
Monitoring parameters
VASCO Solar – VAriable Speed COntroller is equipped with a backlit alphanumeric display and is designed to monitor key electrical parameters like input voltage, power, current and motor power factor.
It is also possible to connect a pressure or flow sensor to monitor performance levels.
In the diagnosis menu are recorded inverter and motor hours, operation statistics, and the last eight alarms occurred. The programming menus are password-protected to prevent unwanted tampering.
Unmatched user
experience
Thanks to Nastec NOW it's possible to communicate with all Nastec devices
Bluetooth® SMART
Complete range
of 4″, 6″, 8″, 10″
submersible pumps
-
Fully AISI 304 stainless steel AISI 316 available on request.
-
Stainless steel impellers and diffusers for maximum efficiency and reliability.
-
Maximum sand content: 50 g/m3.
Three-phase
4″, 6″, 8″ water filled
submersible motors
-
Encapsulated and resinated stator* to grant maximum insulation and heat dissipation.
-
Protection degree IP68.
-
Insulation class F.
-
Max water temperature: 30°C, minimum speed 0.08 m/s.
-
Removable lead connector.
-
Cable for drinking water applications, VDE/ACS/KTW compliant.
-
No-wear, water-lubricated thrust bearing.
-
AISI 316 version available on request.
* as alternative, if required, rewindable motors with a PE2/PA winding insulation can be supplied.
Complete pump protection.
The device is able to protect the pump against overload and dry running.
Dry running protection is performed by monitoring the motor’s power factor and therefore probes are not required.
The device also protects itself against surges and overheating.
